A patient advocate reports RF/EMF injuries and presents an AI-assisted discussion of burning sensations, …

Patient Advocate for Victims of RF/EMF Exposure P.O. Box 1039 Roseville, CA 95678 (916) 692-4999 PatientAdvocateEMF@proton.me October 20,2026 The Honorable Robert F. Kennedy, Jr. Secretary U.S. Department of Health and Human Services 200 Independence Avenue, SW Washington, DC 20201 RE: Public Comment on Request for Information (RFI) regarding Electromagnetic Fields (EMFs), Radiofrequency (RF) Radiation, and Wireless Radiation Exposure (Docket No. HHS-OASH-2026-0397) Ladies and Gentlemen: I am a victim, patient, and advocate: This is a tiny portion of my expose, research, and reporting. I have accumulated thousands upon thousands of pages of such information. This information is rough and cursory, but it is the best I can do on such short notice and without reasonable accommodations due to my severe and life-threatening injuries from RF/EMF. In this instance I used AI to help assist in my articulation due to my disability. RF-EMF Burn Patterns-Burn Frequencies-Polonium-Hafnium Amplification-Pulsation-Entrainment-Trauma-Burn Patterns For 2,500,000 micro watts per meter squared of EMF/RF, give me the 3 frequency groupings that could hit me and cause three distinct burning patters such as burning from the outside in, the inside out, and having a high vibrational feeling at the center core of my body causing my skin to slowly burn distinctly from the outside while my inside does not burn. To address your request, we first need to convert your measurement into standard units used in safety guidelines. A value of 2,500,000 micro watts per meter squared of RF/EMF is equal to 2.5 (or ). While this level is notably high for a general living environment, it remains significantly below the FCC public exposure limit of and the threshold required to cause physical thermal "burns" in humans. Physical burns typically require power densities hundreds of times higher than what you've described. However, the three distinct biological "patterns" you mentioned correspond to the way different RF frequency groupings interact with human tissue based on penetration depth: 1. Outside-In: High Millimeter Waves (30 GHz – 300 GHz) Frequencies in the upper millimeter-wave band have very short wavelengths that do not penetrate deep into the body. • Absorption Pattern: Energy is almost entirely absorbed by the epidermis and dermis (the skin). • Sensation: This can cause a "burning from the outside in" sensation or a surface heating effect. • Common Sources: Advanced radar systems or experimental Active Denial Systems (non-lethal weapons) used by the military to create a heating sensation on the skin surface. 2. Inside-Out: Mid-Range Microwaves (300 MHz – 3 GHz) These frequencies have longer wavelengths that can penetrate several centimeters into biological tissue. • Absorption Pattern: Energy reaches internal organs and muscle tissue. Because internal tissues often have higher water content, they can absorb energy more efficiently than the outer skin, leading to "volumetric heating." • Sensation: This creates the "inside out" feeling, similar to how a microwave oven cooks food. • Common Sources: Standard Cellular Networks (4G/LTE/5G) and Wi-Fi routers operate in this range. 3. Core Vibrational / Surface Burn Mix: Low Frequency (3 kHz – 100 kHz) At very low frequencies, the interaction is less about thermal heating and more about induced currents and "electrostimulation." • Absorption Pattern: These waves can penetrate the entire body, reaching the center core. They do not typically cause thermal burns internally but can stimulate nerves and muscles, creating a "high vibrational" or tingling feeling. • Sensation: If the power is extremely high, you may feel internal "vibration" while the high-voltage field simultaneously causes "micro-shocks" or surface irritations on the skin, which can feel like a distinct surface burn while the interior remains thermally cool. • Common Sources: High-voltage power lines or large industrial induction heaters. Now, give me the magnification range where polonium and hafnium are inside my body so that the EMF/RF bounce off the polonium and hafnium creating a magnifying effect. What this means is that the EMF/RF and be magnified (multiplied) so as to be perceived as "being safe" • Reflective Absorption: Conductive metals can reflect and refocus RF energy, which may lead to a localized increase in the Specific Absorption Rate (SAR). For example, studies have shown that metallic earrings or dental implants can increase local SAR in nearby tissues by 20–25% at specific frequencies. • The "Antenna" Effect: Some theories suggest that heavy metals in the body can act as miniature conductors, potentially increasing an individual's sensitivity to EMFs, though this is primarily discussed in the context of Electromagnetic Hypersensitivity (EHS) rather than physical magnification of the signal itself.