Archive

This protocol and pilot study evaluated whether smartphone signal strength indicators can be converted into RF-EMF exposure estimates using derived formulas and regression models. The study reports a positive log-linear association between LTE RSSI and far-field (base station) exposure aggregated by location, while…

This engineering/methods study proposes an evolutionary computation approach (PCRO-SL) to optimize the selection of measurement points for constructing RF-EMF exposure maps. Tested on real measurements in Meco (Madrid, Spain), it reports good agreement with a reference exposure map while reducing required sampling…

This study reports a measurement-based assessment of outdoor downlink RF-EMF exposure in a French city using drive testing, spot measurements, and a streetlamp-mounted sensor network. The authors report good agreement across methods and correlations between smoothed drive-test data, spot measurements, and base…

This engineering study modeled and tested a distributed wearable RF EMF measurement approach intended to reduce body-proximity effects on personal exposure meter readings. Numerical simulations covered 24 far-field wireless exposure scenarios (100–3600 MHz), and physical tests with three probes were also performed.…

This engineering study evaluates and calibrates an EMF area monitor for the 300 kHz–20 MHz frequency band using a multi-wire transverse electromagnetic (MWTEM) transmission line as a controlled electric-field source. The authors highlight that low-frequency electric-field measurements can be sensitive to boundary…

This protocol describes the third wave of the HERMES prospective adolescent cohort in Switzerland, with follow-up every four months and at one year. The study will assess electronic media use, modeled RF-EMF and transportation noise exposures, and a range of outcomes including cognition, behavior, sleep, mental…

This study compared historical occupational RF-EMF exposure estimates from the INTEROCC RF job-exposure matrix (RF-JEM) with recent personal RF-EMF measurements from the OccRF-Health study in two countries. Agreement between the two approaches was poor for both exposure prevalence and 8-hour time-weighted average…

This case study measured magnetic flux density and RF-EMF on electric buses on two routes in Samsun, Turkey, across different driving conditions and times of day. It reports route- and condition-dependent variability in magnetic fields, with braking associated with higher readings on one route, and lower overall…

This exposure assessment measured in situ smartphone uplink duty cycles for 4G LTE and 5G NR across six voice, video, and data use cases. Measurements were taken at ten positions near a 4G and 5G base-station site in Belgium. Reported duty cycles varied by application, with some use cases showing low-to-moderate duty…

This study conducted personal full-shift RF-EMF measurements in 333 workers across 46 occupations in Spain and France. Most 1-second measurements of electric and magnetic fields were below the device detection limit (≥1% of 1998 ICNIRP standards), though many workers had at least one detectable reading. A small…

This article is a comment on a previously published correlation study assessing whether RF-EMF exposure relates to survey-based health indicators such as sleep, headache, and fatigue. The authors state they performed a detailed analysis of the original study and offer clarifications. The abstract does not provide the…

This study reports a non-contact, non-invasive helmet system intended to measure intrinsic electromagnetic fields generated by the human brain during stereotyped motor tasks. Volunteers performed repetitive tapping, and the authors report discernible wave changes compared with rest and baseline measurements without a…

This study describes a lightweight, inexpensive construct using non-contact EMF sensors to measure dynamic electromagnetic fields attributed to the human brain. Measurements in non-clinical volunteers reportedly differed from background recordings and changed during task performance and auditory stimulation. The…

This paper presents a 3D GIS approach to model magnetic fields from overhead high-voltage power lines while accounting for terrain relief and cable catenary. The model was validated against extensive field measurements in two complex urban environments and showed good agreement with measured values, though accuracy…

This exposure assessment measured RF-EMF levels in 21 state hospitals in Samsun Province, Turkey using short-term, long-term, and band-selective approaches across 100 kHz–3 GHz (total) and 27 MHz–3 GHz (band-selective). The study reports that the ICTA 3 V/m limit was exceeded in at least some hospital measurements,…

This engineering study designed and tested a compact wideband self-grounded bow-tie RF antenna module for a whole-body 7.0 T MRI system, aiming to enable 1H/19F MRI, MR thermometry, and broadband RF thermal intervention. The authors report validated B1 efficiency measurements and phantom-based heating experiments…