Effect of Microwave Radiation Power on the Size of Aggregates of ZnO NPs Prepared Using Microwave Solvothermal Synthesis.
This engineering/materials study tested how microwave heating power affects properties of ZnO nanoparticles produced by microwave solvothermal synthesis. Aggregate size reportedly varied (60–120 nm) with microwave power, while individual nanoparticle size and morphology remained constant (average 27 ± 3 nm) under the stated pressure conditions. Higher microwave power reduced total synthesis time, and the authors proposed a mechanism linking microwave power to aggregate size.
Key points
- Microwave solvothermal synthesis power was varied to assess effects on ZnO nanoparticle properties.
- ZnO aggregate size reportedly ranged from 60 to 120 nm depending on microwave power.
- Increasing microwave power reduced total synthesis time.
- Single ZnO nanoparticles were reported as homogeneous spherical single crystals with average size 27 ± 3 nm.
- Specific surface area was reported as 40 m²/g and skeleton density as 5.18 ± 0.03 g/cm³ for obtained samples.
- A mechanism was proposed to explain the correlation between microwave power and aggregate size.
Referenced studies & papers
Relevant papers in OpenMel
Source:
Open original
AI-generated summaries may be incomplete or incorrect. This content is for informational purposes only and is not medical advice.
AI-generated summaries may be incomplete or incorrect. This content is for informational purposes only and is not medical advice.
Comments
Log in to comment.
No comments yet.